CLO 헬프센터
marin.millar
- 총 활동 수 21
- 내가 팔로우하는 사용자 수 0명
- 나를 팔로우하는 사용자 수 0명
- 마지막 활동
- 투표 수 3
- 구독 수 6
- 회원 가입일
활동 개요
marin.millar님의 최근 활동-
marin.millar님이 에 댓글을 입력함
Thanks for advice. I am using the binding tool and I don't see a layer property for the binding. I tried changing the layer property on the actual pattern piece, but it didn't make a different. ...
-
marin.millar님이 에 게시물을 만듦
Hello, I have binding on an armhole and a neckline. The neckline binding shows correctly, and some of the armhole binding shows, but sometimes it disappears after simulation The binding type is ...
-
marin.millar님이 에 댓글을 입력함
Thank you for the advice. This helped a lot.
-
marin.millar님이 에 댓글을 입력함
Thank you for your help. I did the test and here are the results: Yes, for my project the particle distance is 20mm on each piece and it should be at human scale. Just one thing to confirm..I sh...
-
marin.millar님이 에 댓글을 입력함
How can we switch back to 5.2? My performance is so poor that I cannot even complete the simplest of actions.
-
marin.millar님이 에 댓글을 입력함
Hello, I have followed the recommendations in this post and the reference posts, but my performance is still very slow. It's so slow that I can't even complete my project, which is urgent. Every ...
-
marin.millar님이 에 게시물을 만듦
Hello, I copied a line from one pattern piece and pasted to another. Now I want to replace one pattern line with the copied line. However, when I use the Replace Pattern Outline command, I get an...
-
marin.millar님이 에 댓글을 입력함
Thank you very much! I was alway adding zippers using the zipper tool in the 3D window and it was very difficult sometimes. This tip is really helpful.
-
marin.millar님이 에 게시물을 만듦
Hello, Does anyone have any tips on creating zippers in difficult places? I am trying to create a zipper in the underarm for a ski jacket, and I also tried to created a zipper at the inner thigh ...
-
marin.millar님이 에 댓글을 입력함
Thank you Daniele.