When I activate Simulation the garment starts floating

Follow

r.balsaro

• 2020년 06월 06일 21:43

When I activate Simulation the garment starts floating on the avatar instead of draping over it.

The seams work just fine and the garment assemble properly but it looks like there was "air" coming from under the figure and the garment first inflates and later rides up the figure.

 

Thanks for your help!

0

• danielemanassero

  • 2020년 06월 07일 03:38

  Hi r.balsaro,

  usually this happens when the pieces have a positive pressure value applied.
  Select the pieces and check it up in the property editor.

  Another cause could be an hight thickness collision value in the pieces, or a hight skin offset of the avatar.

  For the thickness collision pay attention when you change the default value  of 2,5 If you type for example 1.5 ( using POINT instead of COMMA) it will be converted in 15

  It is a very commune mistake,I'm still doing it alll the time :)
  
  I hope this help you solve the problem.

  Take care,Daniele

  1

댓글을 남기려면 로그인하세요.