r.balsaro

  • 총 활동 수 10
  • 내가 팔로우하는 사용자 수 0명
  • 나를 팔로우하는 사용자 수 0명
CLO-citizen
  • 마지막 활동
  • 투표 수 2
  • 구독 수 3
  • 회원 가입일

활동 개요

r.balsaro님의 최근 활동

  • r.balsaro님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Imported patterns perimeter points and simulation

    The original patterns were graded, indeed. I see, thanks!  Regards,

  • r.balsaro님이 에 게시물을 만듦

    1. 커뮤니티
    2. Q&A

    Imported patterns perimeter points and simulation

    Hello, I imported some patterns from a DXF file made on Gerber, and I see the points look different than the ones on the patterns generated direcly on Clo. On the attached picture, you ca see the b...

    • r.balsaro
    • 팔로워 2명
    • 댓글 2개
    • 0표

  • r.balsaro님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Floating garments

    Thanks a lot, it was the gravity yeah. As for the colored pattern, it's solidified that's why it looked different :)

  • r.balsaro님이 에 게시물을 만듦

    1. 커뮤니티
    2. Q&A

    Floating garments

    Hello, When I simulate the garments they start floating away from the avatar. Gravity is at 0 Colision 2'5 I haven't touched anyting at all and the garments were simulating just fine up til now. ...

    • r.balsaro
    • 편집된 시간
    • 팔로워 2명
    • 댓글 3개
    • 1표

  • r.balsaro님이 에 게시물을 만듦

    1. 커뮤니티
    2. Q&A

    When I activate Simulation the garment starts floating

    When I activate Simulation the garment starts floating on the avatar instead of draping over it. The seams work just fine and the garment assemble properly but it looks like there was "air" coming ...

    • r.balsaro
    • 팔로워 2명
    • 댓글 1개
    • 0표