주 콘텐츠로 건너뛰기

CLO 헬프센터

어떻게 도와 드릴까요?

Default puckering not showing up in 3D window OR render

댓글

  • US Designer Support

    Hi brifoster

    This could be from a few things in the Puckering Setting. The first is that you have set the Density % very high. The higher the % the more spread out the puckering will be. The lower the % the more tightly packed the pucker will be

    The other is the Intensity of the Normal Map which can be found by clicking the arrow next the normal map. The default is 5, but can be greatly increased

    See below images where In Both the Normal Map intensity has been increased in both, but each has a different density %

    0
댓글을 남기려면 로그인하세요.