Imported patterns perimeter points and simulation

Follow

r.balsaro

• 2022년 11월 14일 18:48

Hello,

I imported some patterns from a DXF file made on Gerber, and I see the points look different than the ones on the patterns generated direcly on Clo.

On the attached picture, you ca see the big, greenish points on the sleeves are from the imported patterns, while the regular ones on the bodice are the ones made used Clo.

I've been having issues simulating my garments, and I see those issues tend to happen when I'm working starting from patterns imported from DXF.. is there a way to avoid those issues, or should I treat imported patterns differently?

Thanks and regards,

 

0

• CLO Designers

  • 2022년 11월 14일 18:52

  Hi r.balsaro
  You can treat the patterns the exact same. The green around the Segment Points is just showing that there is or was Grading applied to the patterns.
  If you begin to grade is a CLO made pattern the same Green Circle will appear on those segment paoints.

  Hope this helps!

  1
• r.balsaro

  • 2022년 11월 14일 19:01

  The original patterns were graded, indeed. I see, thanks! 

  Regards,

  0

댓글을 남기려면 로그인하세요.