faltmann86

  • 活動總數 13
  • 追蹤 0 個使用者
  • 跟隨者 0 個使用者
  • 最後一個活動
  • 投票數 4
  • 訂閱數 3
  • 成員加入日期為

活動概述

faltmann86 的最新活動

  • faltmann86 已評論，

    1. 社區
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    can someone help here? Admin

  • faltmann86 已評論，

    1. 社區
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    ottoline Sorry, I don't get it. Inner Sleeve length measures 42.23cm. POM is created with 42.23cm - but the Property Editors says "Total 3D length" 33.2 cm. The problem here is that the Tech-Pack v...

    • 檢視評論
    • faltmann86
    • 編輯於
    • 1 票

  • faltmann86 已建立貼文，

    1. 社區
    2. Q&A

    Point of Measure vs. Total 3D Lenth?

    Hi there, I hope you guys can help me with this:  I can't find information about this thing called "Total 3D Lenth" and I wouldn't care so much about it if it wouldn't replace my Measurements in t...

    • faltmann86
    • 3 個跟隨者
    • 5 條評論
    • 1 票

  • faltmann86 已評論，

    1. 社區
    2. Q&A
    3. Creating a (furry) flock print using graphics? Need Help, please!

    Thanks a lot. This actually helped if you take care of placing the base  BEFORE you transform it! 

  • faltmann86 已建立貼文，

    1. 社區
    2. Q&A

    Creating a (furry) flock print using graphics? Need Help, please!

    Hi, I'm trying to give my typography graphic (png) a flock print 3d effect by using Fur (Render only). Here's the problem. The fur rendering applies also to the transparent parts of the png. Also t...

    • faltmann86
    • 編輯於
    • 4 個跟隨者
    • 4 條評論
    • 1 票

  • faltmann86 已評論，

    1. 社區
    2. Q&A
    3. Put shirt inside pants

    Hi there, I did all those steps correctly and with normal simulation everything looks fine, but if I simulate in high-res the shirt underneath pops out through the pants fabric slowly. How can I fi...