pablo.quintana My pattern imported with the same issue and I was able to use the trace tool as you suggested to create a pattern piece from the baselines. Thank you so much for the tip!

• 檢視評論
• jeff.yee.designs
• 2024年02月12日 20:22
• 1 票

I'm using fur to simulate velcro and am having the same issue as well. Even when I set the back and side fabric properties to a matte fabric, nothing changes.

• 檢視評論
• jeff.yee.designs
• 2023年12月05日 19:10
• 編輯於
• 0 票

Thank you Lena!!!!

• 檢視評論
• jeff.yee.designs
• 2020年07月13日 23:24
• 0 票

I'm having this same issue with trying to render a section of the animation only. I move the blue slider to the position where I want to start the video but when I try to render, it always goes to ...

• 檢視評論
• jeff.yee.designs
• 2020年07月13日 23:09
• 0 票

Thank you for responding danielemanassero and ottoline. Just a little back story, I am importing DXF-AAMA patterns that I have made and using CLO to render them. Even though there are a few occasio...

• 檢視評論
• jeff.yee.designs
• 2020年01月24日 21:17
• 0 票

Thank you danielemanassero! I tried what you suggested but was unable to pull or push it out (due to my inexperience). I was able to solve the issue by changing the particle distance to 18 from the...

• 檢視評論
• jeff.yee.designs
• 2019年11月21日 22:07
• 0 票

Thank you vadsura and danielemanassero!

• 檢視評論
• jeff.yee.designs
• 2019年11月18日 23:30
• 0 票

This is great information ottoline. Once I get the basics down a bit more, I will look into methods for creating a workflow that suits my needs. Thanks again!

• 檢視評論
• jeff.yee.designs
• 2019年11月13日 17:23
• 0 票

Thank you so much for the feedback! I'm a little over two weeks into trialing the software and its pretty amazing. I like the idea of maintaining the linked editing between patterns so that if I wa...

• 檢視評論
• jeff.yee.designs
• 2019年11月12日 22:16
• 0 票