daiana

  • 活動總數 17
  • 追蹤 0 個使用者
  • 跟隨者 0 個使用者
  • 最後一個活動
  • 投票數 2
  • 訂閱數 7
  • 成員加入日期為

活動概述

daiana 的最新活動

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. RENDERER NOT MOVING TO NEXT IMAGE

    Hi, I just tried to do a simple render with 4 pictures only. It has now been stuck on picture 2 and 12% for 12-13 minutes. The first picture came in about 3 minutes and now it's stuck on picture 2 ...

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. RENDERER NOT MOVING TO NEXT IMAGE

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. RENDERER NOT MOVING TO NEXT IMAGE

    Hi! I had a similar problem a while ago. I was rendering turntables and it wouldn't move on to the next picture. I took about 3 minutes per picture but it always got stuck at some point and wouldn'...

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. Pattern outlines and/or holes are intersecting.

    Hi, I'm getting this error message when I'm trying to change the size from one size to another. Any advice? Thanks Daiana

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. Internal lines follow grading

    Hi, I have a similar problem. The dxf is originally made in Gerber. I don't understand why the internal lines cannot follow the grading, am I doing something wrong when I'm importing the dxf? Anywa...

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. animating garments with .OBJ

    Hi! I  have the same problem. But importing the obj as a trim just makes the fabric fall right through the belt buckle.

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. I MAKE A BUCKLE AND THE FABRIC GO troughs the buckle

    I have the same problem! Importing the .OBJ as an avatar creates another problem --> now the trim is static and doesn´t move.

  • daiana 已評論，

    1. 社區
    2. Q&A
    3. Problem with clo

    I have the same problem someone had 3 years ago, the program closes spontaneously, but no error messages are displayed. I have the trial version installed and the program closes itself without warn...