rjbtsim

  • 活動總數 41
  • 追蹤 0 個使用者
  • 跟隨者 0 個使用者
  • 最後一個活動
  • 投票數 3
  • 訂閱數 14
  • 成員加入日期為

活動概述

rjbtsim 的最新活動

  • rjbtsim 已建立貼文，

    1. 社區
    2. Q&A

    Export notches only on seam allownce

    Would it be possible to introduce a feature when exporting patterns from CLO to only export the notches attributed to the seam allowance rather than the internal lines as well.  This would just red...

    • rjbtsim
    • 3 個跟隨者
    • 1 條評論
    • 4 票

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. 3D Pen (Avatar) not being shown

    This issues has resolved itself for me, not sure if it was fixed in one of the minor updates but I can now see pen lines every time I open a project.

  • rjbtsim 已建立貼文，

    1. 社區
    2. Q&A

    Notch Length Greyed Out

    In notch properties the length is greyed out and I'm not able to change the value. Thanks, Ryan

    • rjbtsim
    • 5 個跟隨者
    • 3 條評論
    • 0 票

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. 3D Pen (Avatar) not being shown

    Thanks

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. 3D Pen (Avatar) not being shown

    Is there any update on this or whether it is going to be corrected?  

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. 3D Pen (Avatar) not being shown

    When I open projects which were saved in CLO 4.2 I still cannot see the lines when opening in CLO 5.0. How can I return to an older version of CLO? I regularly. work from a baseline set of avatar l...

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. 3D Pen (Avatar) not being shown

    I have been saving out as project files (.Zprj) and have not been able to see the 3D lines when re-opening.

  • rjbtsim 已建立貼文，

    1. 社區
    2. Q&A

    3D Pen (Avatar) not being shown

    Hi, Have recently done the update to CLO 5.0. When I save the project, close down CLO and then re-open the project I can no longer see the 3D Pen Avatar lines that I had drawn. I never experienced ...

    • rjbtsim
    • 6 個跟隨者
    • 13 條評論
    • 1 票

  • rjbtsim 已建立貼文，

    1. 社區
    2. Q&A

    Sewing indicators

    Hi, I was just wondering, when viewing seam lines in the 3D Window with the Edit Sewing tool activated, if there is any significance to when 2 indicators are visible as opposed to 1? Thanks, Ryan

    • rjbtsim
    • 2 個跟隨者
    • 1 條評論
    • 0 票

  • rjbtsim 已評論，

    1. 社區
    2. Q&A
    3. Bezier Curve Points and Curve Points

    Thank you.