Help with simulate

Follow

andrealbanna

• 2020年02月28日 06:14

so here's my issue Iset the wait bands upright and when I simulate them it works. however when I unsimulated them and re simulating them (without changing anything) the waits band goes inside. see the 3 screenshots first one being simulated properly second one being unsimulated and how it ends up looking third one is re simulated and it defects,

0

• pablo.quintana

  • 2020年02月28日 14:37

  Andrea, why are you re-simulating? Secondly, your 2D pieces seem to be too small, so there is a huge amount of stretch which will make simulation somewhat unstable.

  Try simulating the pieces again. They should work fine and when locating them close to your avatar use the Arrangement points so the pieces come closer to the avatar and curve a bit.

  0

请先登录再写评论。