faltmann86

  • 총 활동 수 13
  • 내가 팔로우하는 사용자 수 0명
  • 나를 팔로우하는 사용자 수 0명
  • 마지막 활동
  • 투표 수 4
  • 플랜 수 3
  • 회원 가입일

활동 개요

faltmann86님의 최근 활동

  • faltmann86님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    can someone help here? Admin

  • faltmann86님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    ottoline Sorry, I don't get it. Inner Sleeve length measures 42.23cm. POM is created with 42.23cm - but the Property Editors says "Total 3D length" 33.2 cm. The problem here is that the Tech-Pack v...

    • 댓글 보기
    • faltmann86
    • 편집된 시간
    • 1표

  • faltmann86님이 에 게시물을 만듦

    1. 커뮤니티
    2. Q&A

    Point of Measure vs. Total 3D Lenth?

    Hi there, I hope you guys can help me with this:  I can't find information about this thing called "Total 3D Lenth" and I wouldn't care so much about it if it wouldn't replace my Measurements in t...

    • faltmann86
    • 팔로워 3명
    • 댓글 5개
    • 1표

  • faltmann86님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Creating a (furry) flock print using graphics? Need Help, please!

    Thanks a lot. This actually helped if you take care of placing the base  BEFORE you transform it! 

  • faltmann86님이 에 게시물을 만듦

    1. 커뮤니티
    2. Q&A

    Creating a (furry) flock print using graphics? Need Help, please!

    Hi, I'm trying to give my typography graphic (png) a flock print 3d effect by using Fur (Render only). Here's the problem. The fur rendering applies also to the transparent parts of the png. Also t...

    • faltmann86
    • 편집된 시간
    • 팔로워 4명
    • 댓글 4개
    • 1표

  • faltmann86님이 에 댓글을 입력함

    1. 커뮤니티
    2. Q&A
    3. Put shirt inside pants

    Hi there, I did all those steps correctly and with normal simulation everything looks fine, but if I simulate in high-res the shirt underneath pops out through the pants fabric slowly. How can I fi...