Hi Carl, welcome aboard.My name's Daniele from Italy.I'm a pattern maker and also a Clo user.The hardest thing is to apply 3D in the workflow.Designers tend to avoid everything is too tech and to c...

• 댓글 보기
• danielemanassero
• 2018년 08월 02일 12:30
• 3표

Hi All too,I'm Daniele from Italy, probably one of the oldest in this community.I started my career as pattern maker in 1982. So I saw all the new tecnologies since their begin.I'm very happy to be...

• 댓글 보기
• danielemanassero
• 2018년 05월 23일 14:27
• 3표

In my opinion, the avatars are the weakest point of this software.You can't change the shape of the avatars by typing a measure, for example for the three important measures: breast, waist and hip....

• 댓글 보기
• danielemanassero
• 2018년 03월 22일 19:33
• 3표

Helloschirin in the image you can see the option I was talking about. It shows up even in this case there aren't any pins in the scene. Just installed the 5.2.356  Daniele.

• 댓글 보기
• danielemanassero
• 2020년 08월 03일 07:32
• 2표

Hi mdinoulis Create a fabric with the below setup.I use it to create boxes as you can see in the other image.It seams to work better with a low mesh resolution. It is also important to set correctl...

• 댓글 보기
• danielemanassero
• 2020년 06월 12일 10:27
• 2표

hi pitthefem ,  a screenshot woul'd help to understand your problem and help you.A few tips for the straps, mesh 5, the give to the side of the straps pattern the elastic property with a ratio of 1...

• 댓글 보기
• danielemanassero
• 2020년 06월 10일 09:50
• 편집된 시간
• 2표

hi Jeffre yee, I think they don't convert them to hole on purpose, because they will break the mesh. If you want, you can draw a small circle, zooming in the tool will snap to the cross so you can ...

• 댓글 보기
• danielemanassero
• 2020년 01월 21일 07:04
• 2표

Hi smallming, have you tried to remove the linked editing between the hood parts? At least you can create a small rectangle 1/2mm wide and give a render thickness of 2mm and sew it to the inside of...

• 댓글 보기
• danielemanassero
• 2019년 12월 02일 11:41
• 편집된 시간
• 2표

hello jeffyee, that seems more a mesh issue. I think you have a double layer in that corner and the under part has come above.Yuo can solve this problem using the mesh selecting box ( the green mes...

• 댓글 보기
• danielemanassero
• 2019년 11월 20일 14:21
• 편집된 시간
• 2표

Hi Sally, for  now you can change the avatar size from the menu ---> Avatar----> Avatar editor then move the slider near the meas you want to change.( height , width or length) If you enable the sh...

• 댓글 보기
• danielemanassero
• 2018년 12월 11일 06:58
• 2표