CLO 헬프센터
danijel100
- 총 활동 수 16
- 내가 팔로우하는 사용자 수 0명
- 나를 팔로우하는 사용자 수 0명
- 마지막 활동
- 투표 수 3
- 구독 수 5
- 회원 가입일
활동 개요
danijel100님의 최근 활동-
danijel100님이 에 댓글을 입력함
Thank you so much! I was also wondering why for some reason when pattern is not even applied on avatar or used in simulation I still have the different length for 2D and 3D?
-
danijel100님이 에 게시물을 만듦
Hi there, how would you approach excluding yellowed segment? I usually duplicate the whole garment and then use cut; but are there any other way of doing these since that approach kind of slowdown...
-
danijel100님이 에 게시물을 만듦
Hi there, what is the difference between the 2D and 3D length? I have my armhole selected and I am not sure which measure I should use? Thanks in advance!
-
danijel100님이 에 게시물을 만듦
Hi, how should I approach zipper modeling if I want this kind of zipper collar (as in attached picture). When I make just a cut in a fabric my zipper gets twisted in the end. Should I make a recta...
-
danijel100님이 에 게시물을 만듦
Hi there, as the title says how to select one part (arm) of the avatar? I one to hide/deactivate just one arm but when I click to hide it program automatically selects both arms. xx
-
danijel100님이 에 댓글을 입력함
Hi there, it's so much better. It seems like I pushed the fold to far. But still can there is a small puff, you can see it by the picture - is there a way to make it completely flat like it's pres...
-
danijel100님이 에 댓글을 입력함
If I am not wrong there already is an internal line? Photo included.
-
danijel100님이 에 게시물을 만듦
Hi there, I am wondering why my neckband/hem goes this puffy? I dropped particle distance to 5, thickness is 0. The hem is folded edge and the neckband is two piece pattern segment. Please let me...