How to sew the right of label on the wrong side pant?

Follow

mayafeng

• 2021년 12월 17일 03:11

Hello everyone,

When I sew the label on the side of the pant, the label was deformed and embedded in the pant, please inspect the picture below..

I click the front texture surface in 2d window, the first image shows the right side for the pant and the label. when I click the back texture surface in 2d window, the second image shows the wrong side for the pant and the label. In order to sew correctly, how can I display the right side of the label and the wrong side of the pants in 2d window at the same time.

Thank you.

0

• ottoline

  • 2021년 12월 17일 20:51

  Because the cuff of he trouser is turned upwards (inside out) this means the surface normal on that polygon mesh is now negative, so this means the small label wants to simulate to the inside face of the cuff. You can handle this in a few ways > 1# you can change the normal direction on the lable (right click label pattern and flip normals) and then set the label to simulate under, this should change the order of the simulation.  #2 you could use layers by selecting the label pattern , (flip normals) and lower the layering order for that pattern piece in the property editor. # 3 pull the label outwards manually using the mesh select tool (and set it's normal to flipped and layer order to 0).

  0
• mayafeng

  • 2021년 12월 18일 19:48

  Hi ottoline,

  Thanks for the reply. I got it.

   

  0

댓글을 남기려면 로그인하세요.