Suggestion for Improvement_Gradation between X axes and Y axes  D axes
I have graduate a point in X axes and Y axes
When I edit grading of this point I see the measurement of the gradution bewteen X axes and Y axes
When I graduate a point I need to see :
 the X axes (done)
 the Y axes (done)
 the D axes (between X an Y) : Have to be done
I could also graduate, change graduation in D axes

Hi,
For D is that Diagonal? Do you want to see this in the Property Editor?
Can you also give reference to exactly what you are looking for that would be helpful?
1 
The reference size is the basic size 38
The reference size is(in a way) the smallest size
By graduate in X axis, by graduate in Y axis ; I obtain logicly coordinate between axes X et axis Y
That I only see, when "edit grading" the point.
If I am ask to change the graduation in D axis from 7.07mm to 7mm, how I can do that ?
I must have to go back to X axis and Y axis , that is easy when cordinate/value are the same on X and Y axis
But when I have cordinate like this, how can I go to D 0.54cm to D 0.6cm.
Solution
By adding the D value in the property editor, I could change easly the D value
Meaning
It give new X and Y value
0
댓글