Seam Shape

Follow

xyli21

• 2021年04月27日 17:11

Hello!

I'm sewing these two seams together. However, their curvatures are jagged after they were sewn. Their length and shapes are almost the same (6.373:6.402). I'm wondering if I did something wrong or if there is any way to avoid this situation. Thank you very much!

 

0

• 正式なコメント

  CLO Designers

  • 2021年04月27日 18:10

  xyli21 Hello. Those are the 3D seamlines. If you select the seam sewing relationship with the Edit Sewing Tool, you can remove the 3D seamline by deleting the Normal Map in the Property Editor.
• xyli21

  • 2021年04月27日 20:06

  Hi CLO Designers, thank you for your reply. My question might not be clear enough... I meant to create a smooth transition of the seam lines (as the orange line shown below). On my 2D pattern window, the curvatures I created are smooth. However, when I sewn them, them seem to jagged, and turning off 3D Normal Map doesn't seem to help...

  0
• CLO Designers

  • 2021年04月27日 20:15

  xyli21 Oh, my apologies. What is the Particle Distance of the Pattern Piece? Also, what fabric are you using? A lower Particle Distance and a Fabric from the CLO Fabric Library will help visualize the drape. 

  0
• ottoline

  • 2021年04月27日 20:53

  You need an edge tape on that seam to stiffen it.

  0
• xyli21

  • 2021年04月28日 15:12

  CLO Designers I used edge tape to fix it. I'll try to lower the particle distance before I render too. Thank you for your help!

  0
• xyli21

  • 2021年04月28日 15:13

  ottoline Yes edges tape helps a lot! Thank you so much for your help!

  0

サインインしてコメントを残してください。