I would like to know if it is technically possible to model very close fitting garments in Clo.
Specifically I would like to use the software to model corset designs and/or strapless foundation garments with supporting interconstruction.
For waist reduction targets I think you might reduce the avatar waist in the editor to match a target waist reduction as this would allow for a good representation in 3D and allow for accurate pattern/panel sizing. However some of the waist reduction in reality is achieved by tightening the corset in the back with lacing.
So what approach might be taken to configure a specific gap between the back panels where the laces come together?
Corsets and foundation garments often rely on boning to support the garment particularly where waist reduction is desired and where support is needed to make the garment 'stand up' around the bust for example.
Is this possible in Clo? How would you model boning?
I am really hoping this type of drafting is technically feasible in Clo.