Hi Pablo yuo're quicker ! Daniele

• Afficher le commentaire
• danielemanassero
• 12 juin 2020 13:37
• 1 vote

HI mrcedric11111, By default every pattern in Clo is created with a mesh of 20 , selevt the patter and change this value to 5 and you will see the curve come back to is original shape.Daniele.

• Afficher le commentaire
• danielemanassero
• 12 juin 2020 13:02
• 1 vote

Hi r.balsaro, usually this happens when the pieces have a positive pressure value applied.Select the pieces and check it up in the property editor. Another cause could be an hight thickness collisi...

• Afficher le commentaire
• danielemanassero
• 7 juin 2020 03:38
• 1 vote

hi nadiaking It seams you've already done everything properly.Sometime I got that crazy pieces when they were strenghtened and particular distance around 2 or when they had the solidify applied. If...

• Afficher le commentaire
• danielemanassero
• 6 juin 2020 16:59
• 1 vote

You have to disable the show threads in 3d windowsLook at the picture below, in the first, you can see the same problem, In the second the problem solvedDaniele.

• Afficher le commentaire
• danielemanassero
• 6 juin 2020 12:03
• 1 vote

Hi ane4ka not sure waht you mean, but at topstitches you can apply the material type you want ( as for fabrics)Try to play around the opions , some of them are visible just in render ( glass, light...

• Afficher le commentaire
• danielemanassero
• 4 juin 2020 10:01
• Modifié
• 1 vote

Hi ricroma,  first, check the sewing line type, at the border between the two pieces they must be "turned"  second, regulate the thickness collision value of both pieces, by default, this value is ...

• Afficher le commentaire
• danielemanassero
• 17 mai 2020 05:47
• 1 vote

Hi Mattia, check out if view thickness surface is "on" in the 3d windowDaniele

• Afficher le commentaire
• danielemanassero
• 11 mai 2020 09:40
• 1 vote

Hi Minnat, in the  displace's properties the main value is the amount ( default is 3 mm ) that indicate how much hight the map go from the fabric surface. In that garment the amount was probably qu...

• Afficher le commentaire
• danielemanassero
• 23 avril 2020 04:08
• 1 vote

Hi, I'm facing the same issue recently. It seams that when the pin area is very small is more difficult to select it.My way to solve the issue is: select the pattern in 3d window, right-click, then...

• Afficher le commentaire
• danielemanassero
• 17 avril 2020 09:22
• 1 vote