CLO Centro de Ayuda
odellin
- Actividad total 51
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Última actividad
- Votos 1
- Suscripciones 11
- Miembro desde
Resumen de la actividad
Última actividad de odellin-
odellin hizo un comentario,
eufebio Hi Fabio, If you are running a Windows laptop with a decent processor and enough ram, then yes that external box plus that card will work fine. If you're asking me if you can hook it up t...
-
odellin hizo un comentario,
ottoline Thanks, I have your contact on my email now so I'll drop you a line as soon as I can.
-
odellin hizo un comentario,
ottoline Fascinating stuff, really. You write well. Is there a way I can contact you directly? I own a label that might benefit from your expertise in this stuff. Would be great to talk further abo...
-
odellin hizo un comentario,
ottoline To add, I've had my eye on Weft for a while and this indeed should be where the industry heads - much more 'made to order' approach, and if designers can control this element using familia...
-
odellin hizo un comentario,
ottoline PLEASE don't delete your last post, you're bang on the money
-
odellin hizo un comentario,
ottoline I think you make very salient points and I fully understand your rationale (much better than when I posed the initial question). Although I will say that U3M is open source, so I'm not sur...
-
odellin hizo un comentario,
ottoline You wrote two really insightful in depth comments/replies to my last post above that were very enlightening, but they're not showing on the thread? Did you delete them? It would be great...
-
odellin hizo un comentario,
ottoline There's a lot to unpack in your reply (thanks for input by the way) so I'll bullet point a response - hoping to shed light here, not rub anyone up the wrong way. 1. "materials standards ...
-
odellin creó una publicación,
Hi CLO team! Can you tell me please if there is any discussion about bringing U3M to CLO? It's all open source so it would be really great if CLO became a U3M partner. Thanks!
-
odellin hizo un comentario,
knitstudium Absolutely! I completely agree! There is really no need at all to spend lots and lots of money to get a machine that will be perfectly great for CLO, and 100% better than most (if not...