Measurement oddity

Follow

virgosystems

• 22 de junio de 2022 16:38
• Editado

I tried to follow instructions here but when I open avatar editor the dimension isn't shown. As you can see, the avatar shows a measurement but the avatar editor doesn't.  

 

Thanks so much in advance

Joe

 

0

• CLO Designers

  • 23 de junio de 2022 00:10

  HI virgosystems

  The Measurement tool has been updated since those videos were originally made. In order to see the measurements listed there you will first need to add measurements to the Avatar with the Basic Tape measure (Avatar) or the Basic Circumference measure (Avatar) tool. Once you use these to draw the desired measurements the Measure Tab will populate.

  Hope this helps!

  0
• virgosystems

  • 23 de junio de 2022 17:20

  Is there any way to "convert" the existing measurements represented by the dashed lines?

  0
• CLO Designers

  • 23 de junio de 2022 17:54

  Hi virgosystems

  You will have to manually add them if you would like to see them in the measurement page. 

  Those visuals you see with the blacked dashed line represent editable Avatar Measurements that you can adjust in the Avatar Size Tab.

   

  0

Iniciar sesión para dejar un comentario.