CLO Help Center
susanameiras
- Total activity 14
- Following 0 users
- Followed by 0 users
- Last activity
- Votes 0
- Subscriptions 4
- Member since
Activity overview
Latest activity by susanameiras-
susanameiras commented,
Hi, Indeed, I found that was the problem. As many times I use high poly avatars and everything works fine, I didn't expect this would work differently. Thank you!
-
susanameiras commented,
Maybe important to mention that the trim tested is an .obj saved as a trim in CLO.
-
susanameiras created a post,
Hi all, Is anybody who has tried to use the "Collision" for a trim? I've tried to put it 'on', but when clicking on simulation, software gets so so slow that crashes even if I only have the trim in...
-
susanameiras commented,
here it's possible to see what I have obtained when I first applied a different texture. By doing the above, I just reduced my variables.
-
susanameiras commented,
the result is the same whether I use the same or a different texture on the back. Of course I want to use a different texture and I did until I realise there was something wrong on the side view.I'...
-
susanameiras created a post,
Dear all, I have been facing an issue while applying a different texture on the front and back side of the fabric. I've just made a simple test that was to apply a material to a pattern and then to...
-
susanameiras created a post,
Dear all, Do you know if there is any way to run a batch rendering in CLO3D? I have many renderings to run through different project files and I'd like to do it in batch. Many thanks for any advice...
-
susanameiras commented,
Many thanks CLO Designers! However, that solution does not really work when I start the simulation. I put the solidify at 100, I select S-Hardware, particle size 3 and 5; 2mm of thickness and the r...
-
susanameiras commented,
Hi, Many thanks for that! Actually I found different issues when using "obj load as trim" and "obj load as avatar". I want to have the following, in which the fabric goes over a part of the trim li...
-
susanameiras created a post,
Hi, I'd like to animate my avatar wearing clothes that hold accessories. When I use trims, garment mesh passes through the trim mesh keeping the trim over the garment, I can only use an .obj to avo...