CLO Help Center
pablo.quintana
- Total activity 1672
- Following 0 users
- Followed by 25 users
- Last activity
- Votes 98
- Subscriptions 654
- Member since
Comments
Recent activity by pablo.quintana-
Hello Javier. Erica, Javier was asking about the possibility of importing patterns from a PDF into CLO and keep the same colors as the PDF into CLO. Also, if once the pieces are sewn in CLO, re-imp...
-
Hey there Rafael. Did you get an answer about this? I have the same issue where the FEM_GPU allows materials to poke through much easier than FEM_GPU even with the same collision settings. Any co...
-
Tylesfibers, that will depend on the software you are using to open the OBJ. I use Marmoset Toolbag or Blender, and both can import the texture (shaders or materials) exported by CLO. Make sure you...
-
Hey Erica. Here is the link to a project file with the same problems. http://www.clo-set.com/Item/Index/6d810a34814a49f592201aaf8437ae45 Looking forward to your comments.
-
I changed the fabric properties and sewing started acting normal. Weird. P These are the settings for the fabric acting weird:
-
Hello Anh. Trying to open this Gerber exported DXF-AAMA fire with a RUL file for grading, can't be imported in CLO. Can you please check? I will email the file to support@clo3d.com
-
Thanks @Erica. Can you show how are the seams sewn? Did you cut the "drop" shaped piece? P
-
Hey @Erica. I use PAD System using the subscription modality of Padshare. http://share.padsystem.com I'm not affiliated in any way to PAD, but I like to promote it for freelancers becausae of its l...
-
Hello Daniele. Do you use a tablet with CLO? Curious to find out if it is better/faster. Pablo
-
I was about to ask about tablets and their efficiency when I saw your post in the list of old posts. My question to the broader community is: is the tablet an improvement to speed or precision when...