Handbag Zipper will not fall into place when simulating

Follow

d448831

• November 09, 2020 09:35

dear community , i follow the handbag creation tutorial and finished the bag successfully , but now the zipper ( zipper tool , not as in the video with texture)

will not fall into place , its flickering.

 

could anybody help and give advice , what i did wrong :-) thanks Melanie 

1

• Official comment

  CLO Designers

  • November 09, 2020 13:59

  d448831 So far it looks really good! Try this; select the zipper tape and in the Property Editor.  SEE ATTACHED IMAGE) 1. Change the width a bit (default is .197in). This is the size of each side of the zipper (red square). 2. Change the Physical Property preset to Trim Fusible Rigid (red arrow). This will give the zipper tape some stiffness. Simulate again to see the outcome.

  
• ottoline

  • November 09, 2020 23:31

  Switch the simulation quality mode away from GPU and into best quality using the CPU.

  1
• d448831

  • November 10, 2020 12:49

  thanks to both of you :-)

  0

Please sign in to leave a comment.