Sleeve Simulation

Follow

laquishav

• August 03, 2020 20:15

Hello all.  I've just started to use the Clo3d system and I find I'm having a problem with the sleeve simulation. It sews to about the elbow then stops. It finished sewing the sleeve but not onto the arm. Out of about 10 tries it only attached properly once. And advice?

0

• pablo.quintana

  • August 04, 2020 01:38

  Laquishav, make sure the sleeves are close enough to the arms in a way such that the piece will wrap around the arm when simulating. To help you in more detail send an image with the sleeves where you put them just before simulating.

  0
• danielemanassero

  • August 04, 2020 05:44

  Hello, laquishav there 're many ways to fix this problem.
  First, as pablo.quintana suggested be sure to place the sleeve as close as possible to the arms.
  Second, if the problem persists try to sew just the first 15 cm of the underarm sleeve, the rest of the sleeve will fall free in the correct position then you can complete the sewing and simulate.

  Alternatively, the selection mesh(box) is the tool you can use to fix this type of problem.
  Look at the beginners' course on Clo YouTube channel https://youtu.be/TYYR7jFuZ7Y 

  Hope this may help you.

  Daniele

  0

Please sign in to leave a comment.