How can we help you?

New in 2026.0 

Sketch

Set Options

Convert to 3D Pen

Sketch directly on the avatar and turn your lines into patterns instantly. 

Sketch

1. Open an avatar in the 3D window to being sketching.
    

2. In the 3D toolbar, press and hold the 3D Pen (Avatar) and switch to the 3D Pencil (Avatar).
   → The Sketch window appears, and the viewpoint switches to the front view.

   📝Note: To ensure proper conversion to 3D Pen after sketching, the 3D view is fixed to either the front or back view. Only zooming is available.
    

3. Click and drag on the avatar to sketch your design.
     

4. Change the type to Eraser, then click and drag over the area you want to remove.
   → The lines within the dragged area are removed.

Set Options

1. Set the following options as needed.

   Option		Description
   Type	Pencil	Symmetry	Applies symmetrical sketching based on the avatar’s center axis.
   		Conversion Guide	Before converting to 3D Pen, you can see how your sketch will be converted. The segment points shown on the guide line are important, as areas without points will turn into curves. If you need a corner or a defined angle, make sure a point is present at that position. If a corner is missing a point, the edge may become rounded unintentionally. We recommend reviewing the guide and adjusting your lines to achieve the best results before converting.
   	Eraser	Size	Adjust the eraser size to control how much is removed at once.
   Viewpoint		Switch the 3D viewpoint to either the front or back.

Convert to 3D Pen

1. Click the Convert to 3D Pen in the Sketch window.
    → The lines drawn on the avatar are converted to 3D Pen, and the tool automatically switches to the Edit 3D Pen (Avatar). 
    

2. Check the converted 3D Pen and edit it directly as needed. 

✨Tip: For 3D Pens created by sketching on both the front and back simultaneously, flattening both sides automatically sews the front and back together.