CLO Help Center
jrussell
- 活動總數 20
- 追蹤 0 個使用者
- 跟隨者 0 個使用者
- 最後一個活動
- 投票數 0
- 訂閱數 9
- 成員加入日期為
活動概述
jrussell 的最新活動-
jrussell 已評論，
Make sure there aren't internal lines on the edges of your applique pieces. I can't tell because in sewing mode, the edges aren't visible. But you want the edges of your gray fabric pieces to be...
-
jrussell 已評論，
When you see the little arrow, in the lower corner of an icon, it means there are additional tools grouped underneath. The edit curve points tool is, grouped under the edit pattern tool, second fr...
-
jrussell 已評論，
Definitely the issue is that the jacket fabric has additional thickness. However, the only way to change the z-offset of the buttonhole is to add a displacement map. The buttonhole texture file w...
-
jrussell 已評論，
https://support.clo3d.com/hc/en-us/profiles/8551548620313-chalkytannins, I can understand wanting to be able to see inside a garment, and having all the construction detail true to life, but where...
-
jrussell 已評論，
The gap is coming from the fact that your fabric has added thickness, but it's not being depicted in the current view. Switch to "thick textured surface" (alt+1), you're currently in "textured sur...
-
jrussell 已評論，
I think the arrow keys are logical, just counter intuitive when you're not grading off the smallest size. Basically they work the same way at all times, and they need to, because sometimes you're g...
-
jrussell 已評論，
If possible, start by applying grading to points, even if that means duplicating work on both ends of a straight segment. Then switch to curve grading if needed. The odd grading issues seem to co...
-
jrussell 已評論，
Right click on a point or segment that is going wrong and choose "Reset Grading Values". It will clear the work from that selection only. The worst problems occur when grading from a central size...
-
jrussell 已評論，
What's really going on in the render, is that the substance fabric has a small displacement (as well as transparency). So in render, parts of the fabric are being raised above the print, and the pr...
-
jrussell 已建立貼文，
I had a section of trim that I copied using right click, copy to symmetric pattern. I later removed symmetry, to work on something particular to the left side of the garment. I didn't notice at f...