CLO Help Center
marin.millar
- 活動總數 21
- 追蹤 0 個使用者
- 跟隨者 0 個使用者
- 最後一個活動
- 投票數 3
- 訂閱數 6
- 成員加入日期為
活動概述
marin.millar 的最新活動-
marin.millar 已評論，
Thanks for advice. I am using the binding tool and I don't see a layer property for the binding. I tried changing the layer property on the actual pattern piece, but it didn't make a different. ...
-
marin.millar 已建立貼文，
Hello, I have binding on an armhole and a neckline. The neckline binding shows correctly, and some of the armhole binding shows, but sometimes it disappears after simulation The binding type is ...
-
marin.millar 已評論，
Thank you for the advice. This helped a lot.
-
marin.millar 已評論，
Thank you for your help. I did the test and here are the results: Yes, for my project the particle distance is 20mm on each piece and it should be at human scale. Just one thing to confirm..I sh...
-
marin.millar 已評論，
How can we switch back to 5.2? My performance is so poor that I cannot even complete the simplest of actions.
-
marin.millar 已評論，
Hello, I have followed the recommendations in this post and the reference posts, but my performance is still very slow. It's so slow that I can't even complete my project, which is urgent. Every ...
-
marin.millar 已建立貼文，
Hello, I copied a line from one pattern piece and pasted to another. Now I want to replace one pattern line with the copied line. However, when I use the Replace Pattern Outline command, I get an...
-
marin.millar 已評論，
Thank you very much! I was alway adding zippers using the zipper tool in the 3D window and it was very difficult sometimes. This tip is really helpful.
-
marin.millar 已建立貼文，
Hello, Does anyone have any tips on creating zippers in difficult places? I am trying to create a zipper in the underarm for a ski jacket, and I also tried to created a zipper at the inner thigh ...
-
marin.millar 已評論，
Thank you Daniele.