admarcheleta

  • 活動總數 45
  • 追蹤 0 個使用者
  • 跟隨者 0 個使用者
  • 最後一個活動
  • 投票數 20
  • 訂閱數 12
  • 成員加入日期為

活動概述

admarcheleta 的最新活動

  • admarcheleta 已建立貼文，

    1. 社區
    2. Q&A

    Are these bugs or do they just need attention?

    While working I've found some errors I hope the team has noted and also some suggestions to make working in Clo easier. 1. Manual - I wish the manual had more bulk, as in more detail of what each f...

    • admarcheleta
    • 2 個跟隨者
    • 1 條評論
    • 1 票

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Problems exporting patterns to DXF and PDF to open in illustrator

    ottoline that works for single sizes, but does not export the nest.

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Problems exporting patterns to DXF and PDF to open in illustrator

    But what about the notches not showing up pablo.quintana I cannot get notches to export in AI and it doesn't seem like the question is answered on any thread in the community

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Notches Exporting with DXF File

    Also, when you export as PDF there's no grading, so that's really not helpful

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Grading editor issue

    This is me changing the value for All Y to 0 @... When I come back to the point this is the values which have no relation that I can see.

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Grading editor issue

    I just changed all of these points to .125 on the x and 0 on the y. I click a different point and when i come back, since it clearly didn't acknowledge the change on the pattern, it changes to : @...

    • 檢視評論
    • admarcheleta
    • 編輯於
    • 0 票

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. Grading editor issue

    I have this issue with version 6. When I'm grading in offset I put in the desired values and then when I click out or onto another point, it changes to something illogically off from what I set it ...

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. DXF / RUL Import - Help with Grading

    pablo.quintana I do have the .rul file in the same folder with the exact same name. My patternmaker is using TukaCAD. I realize now he added seam allowance which also wasn't showing up in Clo (also...

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. DXF / RUL Import - Help with Grading

    Yes I do.

  • admarcheleta 已評論，

    1. 社區
    2. Q&A
    3. DXF / RUL Import - Help with Grading

    I am having the same issue, but when I load as you suggested, no grading comes in.