CLO Help Center
linusridestore
- 活動總數 14
- 追蹤 0 個使用者
- 跟隨者 0 個使用者
- 最後一個活動
- 投票數 1
- 訂閱數 3
- 成員加入日期為
活動概述
linusridestore 的最新活動-
linusridestore 已建立貼文，
I am trying to figure out a way to delete the shoes of the avatar (I want him/her barefooted for the project I am doing). Anyone who knows a way of doing it?
-
linusridestore 已建立貼文，
Hi! I often have the wish to copy grading from one point to another. Any possibility to do that? Say I have a graded jacket, now I want to apply grading to another jacket I have and the grading rul...
-
linusridestore 已評論，
ok thanks! We use pressure to simulate padding, but should not use it in bottom pants then. Do you have any advice or suggestions who to contact to help us make our avatar more workable?
-
linusridestore 已評論，
Sure your address is correct? Seems that my mail doesn't reach you
-
linusridestore 已評論，
Wow, thank you so much! Just mailed you
-
linusridestore 已評論，
problem is not solved :) Helped a bit though, so the extreme option, how do I do that?
-
linusridestore 已評論，
So increasing skin offset will increase mesh density on avatar?
-
linusridestore 已評論，
Thank you so much guys for your help! <3 I can't see where I can change PD for the avatar, the option only shows when I work with the garment?.. Or do I need another program to edit my avatar?
-
linusridestore 已評論，
Increasing PD didnt help no, how do I check avatar grid and mesh of boots? Any suggestions of articles or tutorials on this area? I'm a beginner...
-
linusridestore 已建立貼文，
I have a lot of trouble with avatar interfering with the fabric. Like at the bottom of the pants on picture attached, the boots (which is avatar) go through the fabric. Bottom of pants is not too n...