Hi Pablo yuo're quicker ! Daniele

• 檢視評論
• danielemanassero
• 2020年06月12日 13:37
• 1 票

HI mrcedric11111, By default every pattern in Clo is created with a mesh of 20 , selevt the patter and change this value to 5 and you will see the curve come back to is original shape.Daniele.

• 檢視評論
• danielemanassero
• 2020年06月12日 13:02
• 1 票

Hi r.balsaro, usually this happens when the pieces have a positive pressure value applied.Select the pieces and check it up in the property editor. Another cause could be an hight thickness collisi...

• 檢視評論
• danielemanassero
• 2020年06月07日 03:38
• 1 票

hi nadiaking It seams you've already done everything properly.Sometime I got that crazy pieces when they were strenghtened and particular distance around 2 or when they had the solidify applied. If...

• 檢視評論
• danielemanassero
• 2020年06月06日 16:59
• 1 票

You have to disable the show threads in 3d windowsLook at the picture below, in the first, you can see the same problem, In the second the problem solvedDaniele.

• 檢視評論
• danielemanassero
• 2020年06月06日 12:03
• 1 票

Hi ane4ka not sure waht you mean, but at topstitches you can apply the material type you want ( as for fabrics)Try to play around the opions , some of them are visible just in render ( glass, light...

• 檢視評論
• danielemanassero
• 2020年06月04日 10:01
• 編輯於
• 1 票

Hi ricroma,  first, check the sewing line type, at the border between the two pieces they must be "turned"  second, regulate the thickness collision value of both pieces, by default, this value is ...

• 檢視評論
• danielemanassero
• 2020年05月17日 05:47
• 1 票

Hi Mattia, check out if view thickness surface is "on" in the 3d windowDaniele

• 檢視評論
• danielemanassero
• 2020年05月11日 09:40
• 1 票

Hi Minnat, in the  displace's properties the main value is the amount ( default is 3 mm ) that indicate how much hight the map go from the fabric surface. In that garment the amount was probably qu...

• 檢視評論
• danielemanassero
• 2020年04月23日 04:08
• 1 票

Hi, I'm facing the same issue recently. It seams that when the pin area is very small is more difficult to select it.My way to solve the issue is: select the pattern in 3d window, right-click, then...

• 檢視評論
• danielemanassero
• 2020年04月17日 09:22
• 1 票