Is there a way to add corner notches in CLO3D e,g they are orientated correctly for someone cutting the pattern to know where to notch the fabric?

When you apply a notch on the corner you are given the option of apply the notch to segment 1 or segment 2 but if it is a corner notch you would want to a notch to both at 90 degrees to each other. This means each pattern needs to be corrected in illustrator which I assume is not what was intended?

See images below:

in the top photo the notch on the on the left hand side is in the correct orientation but the orientation of the top notch is incorrect

and the on the bottom photo the notch orientation on the top line is correct notch on the on the left hand side is the wrong orientation

Is there a way to add two notches to a single corner?

Best

Ryan