Curved Side Geometry on specific sides of pattern piece

Follow

mary

• 2020年10月28日 14:44

I would like to have only certain edges of my pattern pieces. When I select a pattern edge & set the CSG, it sets that for all of the pattern edges. Fot instance, I would like to set the front shoulder seams at 2 for CGS, but the armhole at 0.  As always, any help is appreciated!

0

• 正式評論

  CLO Designers

  • 2021年05月05日 12:31

  mary The option to change the Add'l Thickness Rendering is a visual change that relates to what it will look like when you simulate. Note this option is under "Simulation Properties". You cannot change individual segment thicknesses. The Curved Side Geometry setting is under the Selected Line option and can be adjusted for each segment.
• pablo.quintana

  • 2020年10月28日 15:40

  Just split the edge and you can apply different properties to each segment.

  

  0
• mary

  • 2020年10月28日 16:00

  pablo.quintana Hmmm, for me it does not do that. Even if the line is split, it changes all of the edges on the pattern piece.

  0
• CLO Designers

  • 2020年10月29日 14:29

  Hi Plumconsulting. While you are trying to change the CSG make sure you are only selecting the one segment you want to change and not the entire pattern piece using your Edit Pattern Tool. 

  0
• mary

  • 2020年12月15日 21:39

  This still is not working for me. I am only selecting one segment of the line, but all of the pattern piece edges change.

  Before CSG change from 2.0:

  

  After changing the CGS to the lower segment to 0. Both segments are 0:

  

  0
• CLO Designers

  • 2020年12月16日 15:35

  hI mary make sure that you are also selecting the point as well as the line when changing the CSG.

  0
• mary

  • 2020年12月16日 17:06

  Thanks! I just tried that and it did not work either..I added a point in the middle of the segment to show better. Could it be a pattern issue?

  

   

  

  0
• mary

  • 2021年05月04日 21:04

  I'm back again. I still cannot get different pattern edge thicknesses! I would like the neck line to be Addt'l Thickness of 3 and the waist seam Addt'l Thickness of 4. I purposefully click each point & segment line, but it applies it to the entire pattern piece/all pattern edge instead of the ones I chose. This is driving me batty!

  

  

  

  0
• CLO Designers

  • 2021年05月05日 14:06

  Hi mary. Additional Thickness Rendering can only be applied to the entire pattern piece and not individual edges. Curved Side Geometry is the tool that can be applied to individual edges

  0

請登入寫評論。