Flatten Not Selecting All Pieces

Follow

georgia

• 2024年02月03日 19:43

I have been using the 3D Pen to create the starting points for my pattern pieces. I am using a custom avatar for a ball-jointed doll that I cobbled together and had Fusion 360 remesh it to remove any weird imperfections with the mesh from the Zbrush merges.

When I use the Flatten tool, I cannot select the front piece. I've rebuilt it a few times now. I also closed and reopened the file, closed/reopened the whole application. Nothing seems to work. I even drew another one on the other side and it was fine, but of course I'd like to understand why this is happening. 

Below is a picture. Any ideas?

• #flatten
• #clo_community

0

• CLO Designers

  • 2024年02月05日 09:53

  Hi georgia,

  I cannot replicate the issue on CLO-native avatars, so it might be related to the custom avatar. Are both sides completely symmetrical, since it is working one one? On the side where it worked, had you also created a back drawing already?

  If it is only a "freak occurrence", as long as you can create on one side and make a copy of this pattern piece, the issue will ultimately not matter. It is just not that easy to investigate the exact problem with a custom avatar, as that would be outside of CLO.

  0
• georgia

  • 2024年02月05日 13:43

  You're right! It was the model. I went back to Zbrush and Zremeshed the whole thing, then decimated so it wouldn't create a huge OBJ file. NOW it's great!

  1

請登入寫評論。