faltmann86

  • 活动总数 13
  • 正在关注 0 名用户
  • 关注者数 0 名用户
  • 最后的活动
  • 投票数 4
  • 订阅数 3
  • 成员加入日期

活动概览

faltmann86 的最新活动

  • faltmann86 进行了评论，

    1. 社区
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    can someone help here? Admin

  • faltmann86 进行了评论，

    1. 社区
    2. Q&A
    3. Point of Measure vs. Total 3D Lenth?

    ottoline Sorry, I don't get it. Inner Sleeve length measures 42.23cm. POM is created with 42.23cm - but the Property Editors says "Total 3D length" 33.2 cm. The problem here is that the Tech-Pack v...

    • 查看评论
    • faltmann86
    • 已编辑于
    • 1 票

  • faltmann86 创建了一个帖子，

    1. 社区
    2. Q&A

    Point of Measure vs. Total 3D Lenth?

    Hi there, I hope you guys can help me with this:  I can't find information about this thing called "Total 3D Lenth" and I wouldn't care so much about it if it wouldn't replace my Measurements in t...

    • faltmann86
    • 3 个关注者
    • 5 条评论
    • 1 票

  • faltmann86 进行了评论，

    1. 社区
    2. Q&A
    3. Creating a (furry) flock print using graphics? Need Help, please!

    Thanks a lot. This actually helped if you take care of placing the base  BEFORE you transform it! 

  • faltmann86 创建了一个帖子，

    1. 社区
    2. Q&A

    Creating a (furry) flock print using graphics? Need Help, please!

    Hi, I'm trying to give my typography graphic (png) a flock print 3d effect by using Fur (Render only). Here's the problem. The fur rendering applies also to the transparent parts of the png. Also t...

    • faltmann86
    • 已编辑于
    • 4 个关注者
    • 4 条评论
    • 1 票

  • faltmann86 进行了评论，

    1. 社区
    2. Q&A
    3. Put shirt inside pants

    Hi there, I did all those steps correctly and with normal simulation everything looks fine, but if I simulate in high-res the shirt underneath pops out through the pants fabric slowly. How can I fi...