Handbag Zipper will not fall into place when simulating

Follow

d448831

• 2020年11月09日 09:35

dear community , i follow the handbag creation tutorial and finished the bag successfully , but now the zipper ( zipper tool , not as in the video with texture)

will not fall into place , its flickering.

 

could anybody help and give advice , what i did wrong :-) thanks Melanie 

1

• 正式评论

  CLO Designers

  • 2020年11月09日 13:59

  d448831 So far it looks really good! Try this; select the zipper tape and in the Property Editor.  SEE ATTACHED IMAGE) 1. Change the width a bit (default is .197in). This is the size of each side of the zipper (red square). 2. Change the Physical Property preset to Trim Fusible Rigid (red arrow). This will give the zipper tape some stiffness. Simulate again to see the outcome.

  
• ottoline

  • 2020年11月09日 23:31

  Switch the simulation quality mode away from GPU and into best quality using the CPU.

  1
• d448831

  • 2020年11月10日 12:49

  thanks to both of you :-)

  0

请先登录再写评论。