Simulation problem for my pants - Help

Follow

isayz_7

• 2024年01月17日 09:47
• 已编辑于

Hello, 

I'm new to CLO3D and I have a little problem. I'm currently making an outfit for one of my characters on CLO3D. I just made some simple patterns that I sew to make pants. The problem is that when I run the simulation, my pants don't make sense and look like they're being eaten by my avatar's knee. Do you have a solution to my problem? 

 

Simulation properties for my pants

Thanks in advance! 

Alexis

0

• CLO Designers

  • 2024年01月17日 21:39

  Hi. You may find luck if you reset the pattern in 3D to their arrangement points and then allow the garment to simulate again. Please check that there are no other OBJs or anything in the file with the avatar

  We may also suggest you look at CLO Connect store HERE. There are many styles both free and for purchase. As the pants above will not fit properly. We recommend looking at a few pant patterns and note how side and in seams will need curvature as well as the back rise will be longer than a front rise to sit properly

  0

请先登录再写评论。