How to put a metal ring through eyelets

Follow

a18021267

• 2023年08月03日 19:32

Hey.  I am trying to make a metal ring that goes through eyelets and the fabric should hang from it. I can put it through the eyelets but when I simulate it, it looks like the second picture where it starts shacking like crazy? 

Does anybody know how to solve this? Thanks :) 

1

• CLO Designers

  • 2023年08月04日 13:04

  Hi a18021267,

  - The pattern pieces are colliding into each other upon introduction of gravity (turning on simulation). You can be able to prevent this by going down with both the Particle Distance and the Additional Thickness - Collision of all pieces involved:

  

  (Usually, it is recommended to choose a PD of 5 and ATC of 1 for high resolution, however, these eyelets and rings are so small, you can try with PD 0,8 (smallest possible value) and Collision Thickness of 0,5.)

  - For the metal pattern pieces, you should assign a separate fabric and choose the Physical Properties of Trim_Hardware for it.

  

  - You could also export the rings as OBJs and then add them in as hard objects, but as mentioned, the pattern piece only approach can be successful.

  2
• a18021267

  • 2023年09月11日 15:23

  This worked! Thank you so much!!

  0

请先登录再写评论。