Custom/manual seam allowance intersection/angle

Follow

ashleykirk

• 2023年03月21日 01:06

Hi,

I am making a bodice and have set the seam allowances to .5". Even after changing the seam allowance intersection, there is still an overhang of seam allowance. How can I adjust the seam allowance intersection/angle so that the sewing lines perfectly match up when the pieces are sewn together? See attached screenshot. Thank you!

0

• CLO Designers

  • 2023年03月21日 10:13

  Dear ashleykirk, the different shapes are a result of the blunter and sharper angles on both pattern pieces.

  This will also happen when drafting on paper by hand, but can then be leveled out – in CLO it is a limitation that it is not possible, unfortunately.

  0

请先登录再写评论。