I'm having a hell of a time looping fabric mesh through an obj avatar (bag clip). See attached. It's webbing that I'm trying to loop through an obj - imported as an avatar. A simple webbing strap going through a faux clip for a cross-over bag. I've lowered the PD to 5.0, and on the avatar lowered skin offset to .5 - I've also tried higher skin offsets' so it's less sticky, but still having the same issue. The webbing either pops out or gets stuck inside, bellow or above the obj avatar. I've seen a similar approach to a belt buckles on youtube. I've followed those instructions, unfortunately, without the same success. Appreciate any support to get this to work. Finally, when using the lasso or box mesh select - it's rather fussy with picking a designated area. Sometimes it will select some of the designated area. Whilst other times it doesn't select any mesh at all? Curious why mesh selection isn't seamless at close range. Thank you!