bizarre mesh stretch when simulating

Follow

parsonprof

• 2022年12月15日 19:40

After drafting and sewing a pocket to my jacket, I hit simulate to attach it. Then, this large, abstract form appears and sucks my entire outfit to it. I've never experienced this kind of error  before. Any ideas what's happening?

0

• CLO Designers

  • 2022年12月15日 19:50

  Hi parsonprof

  What attaching the pocket did you use Superimpose before simulating? Superimpose allows items like pockets to move 99% of the way so that during simulation you get minimal collision like you see above.

  You can find a video of this in action HERE

  0
• ottoline

  • 2022年12月23日 03:09
  • 已编辑于

  A good way to reduce collision or assembly performance issues is to use the arrange pattern piece close to the avatar or assembly garment (blue dot), this will cut down on potential assembly simulation errors associated with pattern placement. Also you may need to make sure you don't have the pattern flipped (normals) and that the collision offset is set to the default for the pattern piece. So maybe just run through a checklist for that pattern element.

  0

请先登录再写评论。