Central de Ajuda da CLO
annecworx
- Atividade total 10
- Seguindo 0 usuário
- Seguido por 0 usuário
- Última atividade
- Votos 1
- Assinaturas 2
- Membro desde
Visão geral da atividade
Atividade mais recente por annecworx-
annecworx comentou,
jne4sl Using a single layer and simulating the thickness and edge is exactly what I've done now, and it looks good in my opinion. And with a lot less frustration. Thanks for your advice!
-
annecworx comentou,
Thanks CLO Designers for the tip about strenghtening. That's what I usually do when I fold the first time and it works like a charm. It's just that sometimes when I have to place something in the s...
-
annecworx comentou,
Thanks again jne4sl! Didn't know that option either. I'll try it and if it still doesn't work like I want to, I'll try a trick I saw on youtube (https://www.youtube.com/watch?v=dIzd_-QpTvY&feature=...
-
annecworx comentou,
Forgot to mention... The sewline of the top to the bottom of the cuff has been set to a Turned Seam. It just looks like if you pull too hard on the fabric, the whole thing turns inside out.
-
annecworx criou uma publicação,
Hopefully someone can give me the reason why this happens (a lot) and what to do to prevent this. For cuffs, but also collars, I've used the Fold Arrangement tool to fold the cuff inside, with Fold...
-
annecworx comentou,
Thank you jne4sl! I've tried that option, but didn't go that extra step to change it in both tabs so they're opposite of each other :-)
-
annecworx criou uma publicação,
For a project I have a t-shirt to re-create in Clo. The actual t-shirt I have in front of me, so I can check how everything has been made. This t-shirt has a necktape that also runs under the shoul...