Central de Ajuda da CLO
jdiduch
- Atividade total 26
- Seguindo 1 usuário
- Seguido por 0 usuário
- Última atividade
- Votos 2
- Assinaturas 10
- Membro desde
Comentários
Atividade recente por jdiduch-
There are many options, depending on the level of accuracy required and also budget, as Ottoline has stated, but the main question I think will be how well the software interprets the raw scan data...
-
Daz does not support the UDIM workflow so all your pattern pieces of any given material need to be on one tile. Open up the UV editor and your pieces will all be in a pile together- spread them ou...
-
In the dropdown at the top right of your screen, below Simulation.
-
Ottoline, Thank you for your comments; the chaosgroup link was very enlightening and I will attempt the Blender mod. J
-
I don't have an answer for you, only some personal musings that may help you to understand what might be going on, and apologies if none of this makes sense to you- it barely makes sense to me. I ...
-
Make sure your center line is set to Fold Rendering-On, Fold Angle-0 and turn up the fold strength to something like 60. Don't extend your fold and seam lines right to the edge of your pattern at ...
-
Clo has a reputation for being inaccurate but I think it's probably because many people, like the OP, use the default fabric which is utterly useless for fit validation. Your patterns can be all m...
-
You are probably stuck exporting each size until they set up rul table suport, but send me the file and I'll see if there's anything that can speed up your process. Send it to jdiduch at gmail dot...
-
I used to have problems like that importing Investronica patterns into Gerber- it's not just the grading that's a problem but it also mistook certain internal points and lines for things and gave m...
-
We used to try to avoid dxf conversions at all costs because so much of the data was lost and/or corrupted in the process. Over the last seven to ten years the vendors caught up so that you could ...