Central de Ajuda da CLO
jeff.yee.designs
- Atividade total 43
- Seguindo 3 usuários
- Seguido por 0 usuário
- Última atividade
- Votos 22
- Assinaturas 8
- Membro desde
Comentários
Atividade recente por jeff.yee.designs-
pablo.quintana My pattern imported with the same issue and I was able to use the trace tool as you suggested to create a pattern piece from the baselines. Thank you so much for the tip!
-
I'm using fur to simulate velcro and am having the same issue as well. Even when I set the back and side fabric properties to a matte fabric, nothing changes.
-
Thank you Lena!!!!
-
I'm having this same issue with trying to render a section of the animation only. I move the blue slider to the position where I want to start the video but when I try to render, it always goes to ...
-
Thank you for responding danielemanassero and ottoline. Just a little back story, I am importing DXF-AAMA patterns that I have made and using CLO to render them. Even though there are a few occasio...
-
Thank you danielemanassero! I tried what you suggested but was unable to pull or push it out (due to my inexperience). I was able to solve the issue by changing the particle distance to 18 from the...
-
Thank you vadsura and danielemanassero!
-
This is great information ottoline. Once I get the basics down a bit more, I will look into methods for creating a workflow that suits my needs. Thanks again!
-
Thank you so much for the feedback! I'm a little over two weeks into trialing the software and its pretty amazing. I like the idea of maintaining the linked editing between patterns so that if I wa...