allyshake

  • Atividade total 78
  • Seguindo 0 usuário
  • Seguido por 0 usuário
  • Última atividade
  • Votos 3
  • Assinaturas 24
  • Membro desde

Visão geral da atividade

Atividade mais recente por allyshake

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Dart Manipulation

    I am delighted you were able to incorporate my suggested improvement and you even used my diagram. It is gratifying when a sw developer does this. Unfortunately my old trial expired of Clo 4.0 a lo...

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Print Layout Mode greyed out and discussion on grain line and texture placement

    @goddessofpizza thanks heaps. So am I right in saying the simulation and drape is effected when you put the grain line of the texture on the 45 deg? It looks like it does. I am thinking of bias cut...

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Binding and Edge Finishing a Corset

    Brilliant, the video is very helpful, thanks.

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Print Layout Mode greyed out and discussion on grain line and texture placement

    Oh silly me! I had a fabric applied but no texture. I wanted to see the simulation effects of moving the grain line to the bias direction of the fabric. I am assuming it should stretch more along t...

  • allyshake criou uma publicação,

    1. Comunidade
    2. Q&A

    Print Layout Mode greyed out and discussion on grain line and texture placement

    I am trying to select this mode from the top right hand corner but it appears to be greyed out. Is this because I only have the trial?

    • allyshake
    • 3 seguidores
    • 5 comentários
    • 0 voto

  • allyshake criou uma publicação,

    1. Comunidade
    2. Q&A

    Binding and Edge Finishing a Corset

    I have been experimenting with the binding tool but noticed that it only binds between seam lines and not over them, (see photo). When finishing a corset a long piece of binding, (which may be bias...

    • allyshake
    • 8 seguidores
    • 12 comentários
    • 0 voto

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Cording

    @Anh thanks. That is really interesting about the Bonding. As mentioned above, I have been experimenting using the Attach to Avatar Tape to keep panels in place on the avatar whilst I drape and loo...

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Increasing Avatar's Bust/Cup Size

    I have been using this technique but not achieved the thickness @geniusbutton did. What fabric did you use? Also it would be really useful if there was a Convert Line (Avatar) to Avatar Tape tool. ...

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Cording

    Found an answer to the straight edges question above. New in Clo 4.1 is Edit Line (Avatar) tool, select line, right click and pop up menu now includes option for Flattening as Straight Line. Not su...

  • allyshake comentou,

    1. Comunidade
    2. Q&A
    3. Cording

    Thanks Anh, this is great for what effectively could represent a boning channel. As each channel needs to be a seperate pattern piece the actual cording where the stitch lines are a scant 1/8" apar...