I can't merge please help.
Hello every time I select the CF line I want to merge, it won't let me. What have I done wrong?!
-
Hi jenille. There could be a few reasons for this. I am putting different possibilities below
-Are the CF lines sewn together? If they are not sewn together you will need to select both lines with the Edit Pattern tool First and then R-Click on one of them
-All of your patter outlines are Red. Have you applied Internal lines? If you have you may need to remove these first and then use the above steps.
Hope this helps
0 -
Hi, thank you for your reply. I am very new to using this software. I was tracing around a pattern I had scanned in and drawing around it using the internal polygon line. I tried it again using the polygon line and it would let me merge but would look like this. Is this right?
0 -
Hi jenille. Yes, that looks correct. The mesh is "blending" together, but once you apply Gravity/Simulation it will sit more naturally
0 -
Hi,
Yes it did lay flatter once I added gravity. Thank you for your help.
0 -
Wonderful! Thanks for letting us know :)
0
Comentários