CLO ヘルプセンター
travisnguyen
- 合計アクティビティ 19
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 前回のアクティビティ
- 投票 3
- サブスクリプション 4
- メンバー登録日
アクティビティの概要
travisnguyenさんの最近のアクティビティ-
travisnguyenさんがコメントを作成しました:
US Designer Support Please check attached file and give advice for this case. I hope that the sewing on top look flat. Thank a lot https://1drv.ms/u/s!AuAcyL2kNiCPmJQ8Mp0BgfVMYUOQDw?e=eNzFCD
-
travisnguyenさんがコメントを作成しました:
Hi When I use Layer Clone Over, it will make big recess as picture below. How can I reduce this affect recess? (I want to make sewing effect flat) Thank you
-
travisnguyenさんが投稿を作成しました:
Hi I'm looking method of model this kind of seam in lounge chair. I guess it is French Seam. Need advice to model this kind of seam. Attached file. Thank Link attached file: https://1drv.ms/u/s...
-
travisnguyenさんがコメントを作成しました:
Thank It worked
-
travisnguyenさんが投稿を作成しました:
Hi When I use Layer Clone Over feature, they will make the big gap as below: Then I need to delete sewing then sew again: It will cost the time if I sew again and again. What should I do? Thank...
-
travisnguyenさんがコメントを作成しました:
thank falmouth and ottoline I will learn and try Planar feature later.
-
travisnguyenさんがコメントを作成しました:
Hi Adam I can simulated. However it's too bulging in front and back. What should I do? thank Travis
-
travisnguyenさんがコメントを作成しました:
Hi falmouth Thank for your try. It look good. Could you please share the file, I could learn more about how you Fold fabric. Thank Travis
-
travisnguyenさんが投稿を作成しました:
Hi I need advice to simulate detail of cushion as below: Thank Travis
-
travisnguyenさんがコメントを作成しました:
Hi ottoline Not sure, I understand right? I come back model. Subdivide more polygon then make a seam as below Re-import in Clo3d Could not snap in position of seam I try to draw curve, but still c...