CLO ヘルプセンター
jrussell
- 合計アクティビティ 20
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 前回のアクティビティ
- 投票 0
- サブスクリプション 9
- メンバー登録日
アクティビティの概要
jrussellさんの最近のアクティビティ-
jrussellさんがコメントを作成しました:
Make sure there aren't internal lines on the edges of your applique pieces. I can't tell because in sewing mode, the edges aren't visible. But you want the edges of your gray fabric pieces to be...
-
jrussellさんがコメントを作成しました:
When you see the little arrow, in the lower corner of an icon, it means there are additional tools grouped underneath. The edit curve points tool is, grouped under the edit pattern tool, second fr...
-
jrussellさんがコメントを作成しました:
Definitely the issue is that the jacket fabric has additional thickness. However, the only way to change the z-offset of the buttonhole is to add a displacement map. The buttonhole texture file w...
-
jrussellさんがコメントを作成しました:
https://support.clo3d.com/hc/en-us/profiles/8551548620313-chalkytannins, I can understand wanting to be able to see inside a garment, and having all the construction detail true to life, but where...
-
jrussellさんがコメントを作成しました:
The gap is coming from the fact that your fabric has added thickness, but it's not being depicted in the current view. Switch to "thick textured surface" (alt+1), you're currently in "textured sur...
-
jrussellさんがコメントを作成しました:
I think the arrow keys are logical, just counter intuitive when you're not grading off the smallest size. Basically they work the same way at all times, and they need to, because sometimes you're g...
-
jrussellさんがコメントを作成しました:
If possible, start by applying grading to points, even if that means duplicating work on both ends of a straight segment. Then switch to curve grading if needed. The odd grading issues seem to co...
-
jrussellさんがコメントを作成しました:
Right click on a point or segment that is going wrong and choose "Reset Grading Values". It will clear the work from that selection only. The worst problems occur when grading from a central size...
-
jrussellさんがコメントを作成しました:
What's really going on in the render, is that the substance fabric has a small displacement (as well as transparency). So in render, parts of the fabric are being raised above the print, and the pr...
-
jrussellさんが投稿を作成しました:
I had a section of trim that I copied using right click, copy to symmetric pattern. I later removed symmetry, to work on something particular to the left side of the garment. I didn't notice at f...