CLO ヘルプセンター
jne4sl
- 合計アクティビティ 103
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 前回のアクティビティ
- 投票 11
- サブスクリプション 38
- メンバー登録日
コメント
jne4slによる最近のアクティビティ-
Yes, when you open this topstitch in the property editor, there are tabs 1 and 2 for the two stitches. By default 1 is on Face is front only, and 2 Face is on back only (scroll to the very bottom ...
-
In hand drafting this would be a compass construction, that's why I asked if you where sure the line could span, you aren't just looking to move the line, but to find out where it intersects the ot...
-
I'm unclear, do both the lines exist and you're trying to move one? or are you trying to construct a line. Are you certain a line of this length can span the two objects? Draw a line the correct l...
-
I was just doing this and running into the same thing. Grading down, seems to cause problems. At best the logic seems to be reversed, and whenever there's an automatic calculation points don't mov...
-
This is sewn by apply a bias binding to a slash. At the ends near the cuff, the seam allowance is binding width, but tapers to a minimum near the end of the slash. The inside fold of the binding i...
-
Starting again. The "All" option works fine, never mind that comment. Arrow key grading works fine, but when down grading, the logic reverses, which makes sense. This seems to be a problem when d...
-
You can view the grain line while adding an internal line. Draw a line along the grain line as best you can and then rotate using that. Or for your specific pattern, the bottom of the outseam and...
-
It's working now. At least I'm passed the message and the program has opened. Haven't done anything yet. Thank you.
-
Yes. I'm getting the same thing. I was able to launch and use the beta for several days, but as of Oct. 19, I get this message. Also the online contact forms are not working on the website. I ge...
-
Same. Was using yesterday w/o issue, today login attempt just loops to "Please try again."