I did a little test exploiting buttons as another type of tacking basically to try and get the fold while having directional specific flexibility. Then I just did the normal marking it off with gar...

• コメントを表示
• alexisgz9
• 2025年01月11日 04:16
• 0 件の投票

Ah got it, thank you.

• コメントを表示
• alexisgz9
• 2025年01月09日 23:16
• 0 件の投票

Sorry I mean only pleating the cap and not the side seam, that was what I was trying to show in third sleeve on the bottom in the picture.That is what I mean if the pleating tool had the same behav...

• コメントを表示
• alexisgz9
• 2025年01月09日 20:12
• 0 件の投票

You can see here if I do a diagonal pleat it works fine until you go over 1 inch, then you get the errored out red line of failure. Below that is an example making the pleat tool then cleaning up t...

• コメントを表示
• alexisgz9
• 2025年01月08日 20:18
• 0 件の投票

Imagine the fullness point tool but it pleats instead of slash and spread and you could set internal line length. Does that make sense?

• コメントを表示
• alexisgz9
• 2025年01月08日 18:50
• 0 件の投票

The only problem with the pleat tool is that after the .39x default value for pleats it can error out and not go any larger. I'm not sure if that is because it has to solve both sides at the same t...

• コメントを表示
• alexisgz9
• 2025年01月07日 21:54
• 0 件の投票

Thank you, I do use GPU sim. The only issues I have found with it is after x amount of time it starts to slow down and with a lot of layered pieces there are some collision issues. Is there any way...

• コメントを表示
• alexisgz9
• 2024年12月23日 22:01
• 0 件の投票

thank you for the response. I actually have half the garment turned off and the sleeve is sewn into a piece under the tunic to try and stabilize it. Just turning off 1 sleeve when they get big like...

• コメントを表示
• alexisgz9
• 2024年12月23日 20:44
• 0 件の投票

Hello, here is an example. I want to be able to bevel the fold line so it has a better finish vs the sharp edge look I can get if I just layer clone under and trim off the top. I also want to be ab...

• コメントを表示
• alexisgz9
• 2024年12月20日 22:55
• 0 件の投票