1. コミュニティ
2. Q&A

I am trying to select this mode from the top right hand corner but it appears to be greyed out. Is this because I only have the trial?

• allyshake
• 2018年07月20日 00:23
• 3フォロワー
• 5件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

I have been experimenting with the binding tool but noticed that it only binds between seam lines and not over them, (see photo). When finishing a corset a long piece of binding, (which may be bias...

• allyshake
• 2018年07月19日 23:41
• 8フォロワー
• 12件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

Is it possible to simulate cording in Clo. I would like to stitch a two layered panel together with multiple rows of stitches at say 1/8" apart and fill these with cord. If this can be simulated wi...

• allyshake
• 2018年07月17日 20:43
• 2フォロワー
• 7件のコメント
• 1件の投票

1. コミュニティ
2. Q&A

Is it possible to turn off perspective for the default camera so you have effectively a flat orthographic view in the 3D window? I tried setting the default camera FOV to zero but this causes probl...

• allyshake
• 2018年07月17日 02:48
• 3フォロワー
• 3件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

I would like to know if it is technically possible to model very close fitting garments in Clo. Specifically I would like to use the software to model corset designs and/or strapless foundation gar...

• allyshake
• 2018年07月10日 20:38
• 編集済み
• 4フォロワー
• 17件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

Will you be uploading the recent webinar to Youtube. I missed it because it was on too early in my time zone. Thanks

• allyshake
• 2018年05月24日 21:13
• 2フォロワー
• 4件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

I see there is a an Add Dart tool in Clo. However is it possible to use the Slash/Spread technique often used when designing to shift/pivot the dart excess from one position to another in a bodice....

• allyshake
• 2018年05月10日 02:24
• 4フォロワー
• 5件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

Is it possible to use another software program to draft a pattern then import this into the 2D window? If so what format would the draft need to be in? Would you have to trace that imported pattern...

• allyshake
• 2018年05月07日 20:15
• 2フォロワー
• 1件のコメント
• 0 件の投票

1. コミュニティ
2. Q&A

In the avatar measurement editor, is it possible to enter the measurements with the keyboard or can you only use the sliders. If I double click the measurement it is highlighted but I can't change it.

• allyshake
• 2018年05月07日 19:11
• 5フォロワー
• 10件のコメント
• 0 件の投票